|
|
|
Lighthouse Anchoring Instructions WOODEN BOAT DOCK OR DECK: Screw through the wooden base of the lighthouse with galvanized screws or lag bolts into any solid wooden foundation. GARDEN OR YARD: Pre-drill two 3/8" pilot holes into the wooden base of the lighthouse. Dig a hole 4" deep and approximately 6-8" wider than the base diameter of your lighthouse. Mix 2 bags of Sak-Crete concrete with water (per the directions on the bag). Allow at least 24hrs for the concrete to harden. Center the lighthouse on the concrete pad and place two pencil marks through the pilot holes of the wooden base. Remove the lighthouse and use a ½" masonry bit and drill two hole approximately 3" in depth. Embed the 3/8" anchor nuts in the concrete and attach the lighthouse using 3" galvanized lag bolts and washers. OR TRY OUR "NEW" ROCK BASE
Lighthouse
Rock Base: Now anchor your lawn
lighthouse to our our "NEW" Rock Base.
No need to pour a concrete slab or lag bolt your lighthouse to a secure surface.
Simply attach your lighthouse to our beautiful rock base. You will be
amazed how our decorative stone base brings an element of realism and
authenticity to any yard, garden, deck, pool, or
lakeside location. Features architectural stone and cemetery grout that is
built to last for a lifetime. Base Measurements 35" x
35" by 11" high & weighs approximately 80 lbs. Stone base
will work on all 3'-5' Custom Crafted Stucco Lighthouses. Lighthouse Rock Base $169.00 + 50.00 S/H
|
|
|
